OpenRoads Tip: Mirroring Entire Template During Creation

When providing training on the corridor modeling functionality in the OpenRoads tools, I am often asked if it is possible to mirror the work done on a template to the other side. It is possible to insert the active template into itself, allowing for the “reflect” functionality to be used while dragging and dropping components to effectively mirror an entire template. Remember to verify your point and component naming.

Steve Litzau

Steve is a Senior Consultant at EnvisionCAD with over 15 years of experience in linear and site design, and design technology support. He serves as a subject matter expert for civil design software on both the Bentley and Autodesk platforms.