OpenRoads Tip: Working with Geometry and Snap Constraints

July 29, 2016

Written by: Bob Mecham

In this OpenRoads Geometry tutorial we will show you how Snap Constrains are created and how make sure that they are not used.  We will also show you how to remove a snap constraint after it has been applied.  Contact us for OpenRoads Training, Consulting, and Setup.

Bob Mecham

Bob Mecham

Bob joined the training and consulting firm EnvisionCAD in 2000 and became a partner in June of 2002. He has specialized in the software MicroStation & InRoads from Bentley Systems, Inc. Mr. Mecham is an industry expert in the implementation, configuration, development, and customization of the two software applications MicroStation and InRoads. Bob instructs MicroStation classes ranging from fundamentals to advanced productivity. He has extensive experience using, implementing, and instructing both InRoads Survey and InRoads Site Design. Bob received his degree in Civil Engineering Technology from the Madison Area Technical College in 1992 and has over a decade of experience in the use, implementation, and management of software and CADD systems. He has worked for a wide range of organizations providing services from general survey and engineering services to specific applications such as landfills and site design.

Tags: ,

Archives

Leave a Reply

Your email address will not be published. Required fields are marked *

Additional Resources for OpenRoads